Paradyne 6800 - Manual (Page 124)

COMSPHERE 6800 Series Network Management System
4-20 January 1997 6800-A2-GN22-30
DL5600
The DL5600 offers both serial and parallel connections. It can be connected to any available port
on the host processor. If you use the parallel port, follow the instructions shown above under
DL3400/DL3600.
1. Connect the grounded end of the 035-0153-0031 cable directly to an available port on the
IPC-1600 card. To use the COM port, you must first connect the 035-0153-0031 cable to
the 002-0054-0031 connector.
2. Connect the other end of the 035-0153-0031 cable to the 002-0040-0031 connector.
3. Connect the 25-position end of the 002-0040-0031 connector to the RS-232 serial port on
the printer.
Connecting a Remote System Printer
Only the DL5600 can be connected remotely. It requires connection to a serial port on the
IPC-1600 card in the host processor. Two 2224CEO DDD modems are also required.
To establish the connection, perform the following steps:
1. At the host processor end, connect the grounded end of the 035-0153-0031 cable to an
available serial port on the IPC-1600 card.
2. Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.
3. Connect the 002-0039-0031 connector to the local modem.
4. Connect one 2224CEO DDD modem to the Network Channel Terminating Equipment
(NCTE). Option the modem appropriately.
5. At the printer end, connect one end of the 835-5783-0011 cable to the serial port on the
DL5600.
6. Connect the other end of the 835-5783-0011 cable to the remote modem.
7. Connect the modem to the NCTE. Option the modem appropriately.
See Appendix A, Modem Settings, for information on optioning the 3810, 38811, 3820, or
2224CEO modems.
Connecting an Alert Log Printer
DX2300
The Fujitsu DX2300 can be connected to the COM1 or COM2 serial ports or to an available serial
port on the IPC-1600 card in the host processor. To establish the connection, perform the following
steps:
1. Connect the grounded end of the 035-0153-0031 cable to an available port on the IPC-1600
card in the host processor. Use the 002-0054-0031 connector if you are connecting to a
COM port on the host processor.