Paradyne 6800 - Manual (Page 259)

COMSPHERE 6800 Series Network Management System
5-98 January 1997 6800-A2-GN22-30
2. The system displays the following message:
Please select the 6510.
1. “System name”
2. Cancel operation
Enter a number from 1 to 7 depending on the number of 6510’s configured already.
TYPE: number of the system to be changed
PRESS: Enter
3. The system prompts you to change the ANALYSIS name, port number, and the number of
local terminals on the ANALYSIS NMS. The current parameters display in brackets ([]).
The following message appears:
Enter Analysis 6510 name, 15 characters max [“system name”]...
TYPE: the new system name
PRESS: Enter
Select port number from list [[1],2,3,4,5,6,7,8]...
TYPE: the new port number
PRESS: Enter
How many local terminals (1 — 6) are configured on this 6510 [“value”]?...
TYPE: the new number of local terminals
PRESS: Enter
4. The system displays the information entered in Step 3 and prompts you for confirmation.
You have entered the following information:
ANALYSIS 6510 name = “name”
Port Number = “value”
Number of local terminals = “value”
Is the information correct [y or n, q to quit]?...
TYPE: y (or n if the information is not correct)
PRESS: Enter
If you enter n (no), the three prompts shown in Step 3 are displayed again enabling you to
enter information. If you enter y (yes), the following message appears.
parameters successfully changed
5. The ANALYSIS Selection menu appears. For additional changes, return to Step 1. To exit
the procedure,
TYPE: 4
PRESS: Enter