Paradyne 6800 - Manual (Page 160)

COMSPHERE 6800 Series Network Management System
4-56 January 1997 6800-A2-GN22-30
Bytex UMS
This section explains how to connect the Bytex UMS to the NMS host processor or the User
Interface Processor (UIP). The UIP connection is restricted to cut-through only.
To connect the Bytex Switch to the host processor or UIP, you will need the following materials:
•
035-0153-0031 10-pin modular to 10-pin modular cable
•
002-0039-0031 ACU/MODEM adapter
Figure 4-28 illustrates the connection for both the host processor and UIP to the Bytex UMS for
either the Bytex alerts or cut-through.
Connecting the Host Processor to the Bytex UMS
To connect a host processor to the Bytex UMS, perform the following steps:
1. Connect the grounded end of the 035-0153-0031 cable to a port on the IPC-1600 card.
2. Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 ACU/MODEM
adapter.
3. Connect the 002-0039-0031 ACU/MODEM adapter to a port on the Bytex UMS.
Figure 4-28. Bytex UMS Connection