Paradyne 6800 - Manual (Page 70)

Preparing the Processors
2-47 6800-A2-GN22-30 January 1997
The EISA Configuration Disk is a bootable disk. To run the program, you will need to boot the
processor with this disk. To do this, perform the following steps:
1. Insert the EISA Configuration Disk into the floppy disk drive. Turn the power switch to the
ON position. (If the RESET/RUN switch is not in the RUN position, turn the key
clockwise until it is in the RUN position.) The system begins to boot. If you are running
the ECU on a System 15000, go to Step 3. The system briefly displays the following
message:
Press spacebar to interrupt autoboot
NOTE
You have approximately 10 seconds to press the spacebar to
interrupt the autoboot sequence and allow booting from the floppy
disk. Failure to do this within the 10-second window allows the
system to start up from the hard disk and requires a reboot.
2. Immediately press the spacebar. The boot menu appears, as shown in Figure 2-24.
TYPE: 2
to select boot from floppy.
491-13836
Select [1] to boot from hard disk
Select [2] to boot from floppy
Select [3] to boot from tape
Select [4] to enter BIOS setup
Enter option:
Figure 2-24. Boot Menu
3. Press any key to dismiss the EISA logo and display the Welcome screen. Then,
PRESS: Enter
to display the Main Menu. It is shown in Figure 2-25.