Paradyne 6800 - Manual (Page 187)

COMSPHERE 6800 Series Network Management System
5-26 January 1997 6800-A2-GN22-30
b. For the 15000 system, you must shutdown and power off. Then, power on to activate
the kernel. To do this, remove the floppy disk and cartridge tape, and
TYPE: cd /
PRESS: Enter
TYPE: shutdown -g0 -y -i0
PRESS: Enter
When the system prompts:
** Safe to Power Off **
- or -
** Press Any Key to Reboot **
Rotate the key counterclockwise 1/4 turn to the vertical SWITCHED OFF position. Wait
at least 45 seconds for the processor to power down. Then, rotate the switch clockwise 1/4
turn to the RUN position. The system will reboot.
Formatting the Third Hard Disk
On host processors with the Automatic Backup and Restore package, you must format the third
hard disk required by that package. The Automatic Backup and Restore package is always present
on the Altos 15000 host. To format the third hard disk, perform the following steps:
1. After rebooting the processor, when the following message appears:
Type (CONTROL-d) to proceed with normal startup (or give root
password to enter system maintenance):
TYPE: root password
PRESS: Enter
2. At the UNIX system prompt,
TYPE: cd /usr/nms/adm
PRESS: Enter
TYPE: ./install3hda
PRESS: Enter
NOTE
If the disk has already been installed and formatted, the following
message appears:
The 3rd hard disk is already installed.
Skip the remaining steps and proceed to Step 5.