Virtual management port settings (cli), Irtual, Anagement – Promise Technology 2-Year Extended Warranty for VessR2000 RAID Head User Manual
Page 99: Ettings, Cli) 72, Aking, Utomatically, Cli)
V
irtual
M
aNageMeNt
p
ort
s
ettiNgs
(cli)
M
Aking
v
irtuAl
M
AnAgeMent
P
Ort
s
ettings
– A
utOMAticAlly
(cli)
Automatic settings require a DHCP server on your network. DHCP is currently supported on IPv4 only.
To enable automatic management port settings:
1. At the command prompt, type
net -a mod -f ipv4 -s “dhcp=enable”
and press Enter.
administrator@cli> net -a mod -f ipv4 -s “dhcp=enable”
After a moment, the comand prompt reappears, indicating that your setting was successful.
administrator@cli>
2. To verify the setting change, at the command prompt, type
net
and press Enter. The following
information displays:
administrator@cli> net
==========================================
PF Status IP
Link
==========================================
IPv4 Enabled 10.0.0.1
Up
IPv6 Disabled :: Up
In the above example:
• PF refers to IP protocol family, v4 or v6
• Status refers to whether the IP protocol is enabled. IPv4 is enabled by default.
• IP is the virtual management port IP address.
• Link indicates whether there is a working network connection.
By default, IPv4 is enabled and IPv6 is disabled.
72
Vess R2000 Series Product Manual
Promise Technologies