Promise Technology 2-Year Extended Warranty for VessR2000 RAID Head - Manual (Page 333)

306
Vess R2000 Series Product Manual Promise Technologies
Summary
The array command is the main command for performing advanced configuration and
maintenance tasks on disk arrays.
This command is used to list, create, modify, delete, and locate disk arrays. Also to add and
delete logical drives.
Note that you cannot mix Hard Disk Drives (HDD) and Solid State Drives (SSD) in the same
disk array.
Options
-a Specifies the action to perform.
list (Default) Displays a summary of all or a specific or a specified
number of arrays.
add Add/create an array and possibly some logical drives
at the same time.
addld Add/create a logical drive to an array that already
exists.
delld Delete an existing logical drive from an array.
mod Modify settings of an existing array.
del Delete an existing array and all its associated logical drives.
locate Locate an array.
accept Accepts the condition of an incomplete array. There are two
conditions that will cause the array to report as incomplete:
• Missing Drive , i.e. when one or more drives are missing in the array.
• Missing NVRAM Watermark , the NVRAM Watermark of migration
not found on the controller, however the DDF on the array
indicates the migration is in progress.
When the either of the above condition happens, all the logical drives on the