Promise Technology 2-Year Extended Warranty for VessR2000 RAID Head - Manual (Page 691)

664
Vess R2000 Series Product Manual Promise Technologies
Reported Event Corrective Action
Synchronization
Synchronization is started No action is required.
Synchronization is completed No action is required.
Synchronization is paused Resume synchronization when ready.
Synchronization is resumed
No action is required.
Synchronization is stopped
Synchronization is aborted due to an internal
error.
Reduce system load on the Vess.
Synchronization is queued
No action is required.
Synchronization is stopped internally
Subsystem (Vess)
The Subsystem is started
No action is required.
The Subsystem is stopped
Subsystem parameter(s) are changed by user
System is set to Redundant mode
System is set to Critical mode Check controller operation.
System is set to Non-Redundant mode If your system has two controllers, check
controller operation.
Transition
Transition is started
No action is required.
Transition is completed
Transition is paused Resume transition when ready.
Transition is resumed No action is required.
Transition is stopped If this action was not intentional, check the
disk array’s status.
Transition was switched to rebuild Replace the dead physical drive or
reinstall the missing drive.
Unknown
Unknown priority reason is detected If this message appears repeatedly,
contact Tech Support.
Zoning
Zoning permission settings with the expander
has been reset to defaults No action is required.
Zoning expander has been rebooted.
Zoning permission settings with the expander
different than expected
Settings have been updated correctly. No
action is required.