Removing the old controller, Installing the new controller, Emoving – Promise Technology 2-Year Extended Warranty for VessR2000 RAID Head User Manual
Page 575: Ontroller, Nstalling

548
Vess R2000 Series Product Manual
Promise Technologies
r
eMoViNg
the
o
ld
C
oNtroller
To remove the RAID controller:
1. Shutdown the Vess R2600.
2. Disconnect all attached cables from the RAID controller,
• Fibre Channel cables
• iSCSI cables
• SAS expansion cables
• Management port cables
• Serial cable
• UPS control cable
3. On the controller handle, squeeze the release tab and pull the handle outward. See “RAID controller
release handle and pull out” on page 545.
4. Pull the RAID controller out of the subsystem enclosure.
i
NstalliNg
the
N
ew
C
oNtroller
To install the new RAID controller:
1. Carefully slide the RAID controller into the enclosure.
2. Gently swing the handle in and press the handle until it locks.
3. Reconnect all cables that were attached to the RAID controller.
• Fibre Channel cables
• iSCSI cables
• SAS expansion cables
• Management port cables
• Serial cable
• UPS control cable
4. Press the power power.
The Vess R2600 restarts.
5. Log into the Vess R2600.