Promise Technology 2-Year Extended Warranty for VessR2000 RAID Head - Manual (Page 402)

375
Product Manual Managing with the CLI
-p Specifies the port number of the TFTP server. If no port number is
given, the default value that will be used is 69.
-e Specifies the Enclosure ID.
Only used with -a versioninfo option.
If not specified, default value is all enclosures.
-i Specifies the Controller ID.
Only used with -a versioninfo option.
Enclosure id is required when controller id is specified.
If not specified, default value is all controllers.
-n Start the flash process/image update in NDIU mode.
This mode is applicable only if the system is in redundant state.
Default mode of flash is DIU (disruptive) mode.
-d Specifies the physical drive IDs.
Only for physical drive firmware update.
If not specified, all the physical drives, which are supported by the
specified physical drive firmware, are selected.
-l Display the status of currently running flash process.
-y Enable non-interactive mode.
Examples
ptiflash -t -s 192.168.1.1 -f fw_multi.ptif -p 69 # for embedded
ptiflash -f fw_multi_20031010.ptif # for in-band
ptiflash -l # list currently running flash process
ptiflash -t -s 192.168.1.1 -f fw_multi.ptif -n # for NDIU mode
ptiflash -t -s 192.168.1.1 -f pd_fw.ptif -d 1,2
# update the pd firmware for pd 1 and 2 using the pd_fw.ptif image.