Apple Logic Pro X - Manual (Page 490)

Chapter 16 Mix a project 490
Reset all clipping indicators
m Click any clipping indicator (or use the Clear Overload Flag in Audio Channel Display key
command).
Set channel strip volume levels
You can set the volume level of each channel strip independently, balancing the relative volume
of the tracks in your project. You can also quickly switch between two different volume levels on
a channel strip.
Set a channel strip’s volume level
Do one of the following:
m Drag the Volume fader up or down.
Volume fader
Level meter
m Option-click the Volume fader to return it to a neutral level (0 dB gain).
m Hold down Shift while dragging the Volume fader to change the volume level in
finer increments.
The level meter, located to the right of the Volume fader, shows the channel strip output volume
as the project plays. When you record, watch the level meter to make sure the channel strip
volume is not too high.