Apple Logic Pro X - Manual (Page 143)

Chapter 6 Work with projects 143
Move the cycle area
m Grab the yellow cycle strip by the middle (the pointer turns into a hand) and drag it horizontally.
Resize the cycle area
Do one of the following:
m Grab the left or right edge of the cycle area to move the start or end points.
m Shift-click a position in the ruler.
This works even when the stripe is outside the visible range, or Cycle mode is turned off.
Create a skip cycle
1 Set the cycle area to the part of the project you want to skip.
2 Click the Swap Left and Right Locators button in the control bar (or use the Swap Left and Right
Locator key command).
The cycle area changes color, indicating that it is now a skip cycle.
You can add the Swap Left and Right Locators button by customizing the control bar. For
information, see
Customize the control bar .