Grass Valley 4300 Krystal Reference Manual v.3.1 - Manual (Page 98)

6-4 Krystal 4300 Reference
Section 6 — Run Control Menu
Transformation Path Control Menus
Krystal effects that require transformation path menus bring up the fol-
lowing soft buttons and soft knobs to let you control how your effect is
transformed. A typical Transformation Path control menu is shown below:
The following soft button and soft knob controls are used with this menu:
HOLD — when ON , no motion interpolation occurs, which will make the key-
frame jump to the next keyframe location. The length of time that the effect
sits on each keyframe is set by the keyframe duration (default is 1 second).
PATH TYPE — path type selections are:
CURVE — causes a smooth and rounded path through the keyframe.
Paths are user adjustable via the soft knobs with path modifiers (ten-
sion, continuity, and bias) described below.
SMOOTH — This feature is not currently implemented. If selected, a
curve path with default values will be used.
LINEAR — applies a linear interpolation between keyframes; no acceler-
ation or deceleration is applied. Movement is mechanical having a con-
stant velocity.
S-LINEAR — applies a linear or straight line motion between keyframes,
with acceleration and deceleration applied at the beginning and end of
each keyframe.
Tension, Continuity, and Bias Controls
When the CURVE parameter is selected, the three Soft Knobs provided are:
LOCATE PATH
Displayed:
Register:
Keyframe:
Cur.Time:
HOLD PATH
TYPE
S-LINEAR
ON LINEAR
SMOOTH
CURVE
OFF
BIAS
0.0000
CONTINUITY
0.0000
TENSION
0.0000