Grass Valley 4300 Krystal Reference Manual v.3.1 - Manual (Page 138)

7-30 Krystal 4300 Reference
Section 7 — Picture Menu
Freeze/Timing
The TIMING selection applies to all of the recursive modes and is discussed
near the end of this section on page 7-36 .
Motion Decay/Appearance
The MTN DECAY selection causes motion in the video image to leave a blurred
remnant behind as it moves. The APPEARNCE selection allows you to modify
the appearance of the motion decay.
To access the Motion Decay/Appearance selections shown below, press the
RECURSIVE MODE soft button to select MTN DECAY , and press the MODIFY soft
button to select APPEARNCE .
APPEARNCE — allows you to adjust the appearance of the motion decay
using the selections and soft knobs described below:
DECAY — sets the mix of old video to new video. The zero setting results
in no new video.
LOOP — ON starts the recursive effect. OFF stops the recursive effect and
returns to live video.
KEYFRAME RESET — ON resets the loop and starts the recursive effect over
again at each keyframe where Keyframe Reset is on. OFF does not reset the
loop at each keyframe.
Motion Decay/Timing
The TIMING selection applies to all of the recursive modes and is discussed
near the end of this section on page 7-36 .
OUTPUT RECURSIVE
Displayed:
Register:
Keyframe:
Cur.Time:
RECURSIVE
MODE
MODIFY LOOP KEYFRAME
RESET
DECAY
20.0000
OFF
ON
OFF
ON
TIMING
APPEARNCE
OFF
TRAILS
MONTAGE
MTN DECAY
FREEZE