Grass Valley 4300 Krystal Reference Manual v.3.1 - Manual (Page 253)

Krystal 4300 Reference 11-17
Combiner Menus
See Section 6-Run Control Menu for more information about path control
functions.
Combiner Menus
The combiner menus are used to set up how the optional Combiner pro-
cesses its input signals to create its combined output signals. Most Krystal
combiner parameters are stored in the Camera channel. These combiner
parameters are saved to Krystal registers and to disk as Camera channel
information.
The controls active on the combiner menus can vary, depending on
whether the camera channel or a logical channel is delegated. Inactive con-
trols are grayed out.
Note If the Camera and more than one logical channel are delegated, and the Camera
is the display channel, the parameter values for the lowest numbered delegated
logical channel will be displayed. If a logical channel is the display channel and
the Camera channel is delegated, Camera channel parameters will be displayed
along with those for the logical channel.
Two different sets of Combiner menus exist, one set for the 4 Channel Com-
biner option, and one for 2 x 2 Combiner option. The appropriate set of
menus will be displayed, depending on which type of Combiner is config-
ured with your currently acquired Effect Manager.
4 Channel Combiner Control Menu
Press Input/Output \ COMBINER CONTROL > to access the Four Channel Com-
biner Control menu. A graphical representation of the combiner stages and
signal paths appears on this screen.
Displ: Camera
Re: 1 - Register
KF: 1 of 5
Time: [0.00]
Primary
2ndary
INPUT
OUTPUTS
CHANNEL
COMBINING
STAGE 3
STAGE 2
STAGE 1
DEPTH
VARIABLE
NORMAL
MODIFY MODIFY
STAGE
MIX
MODE
2) MIX LEVEL
0.0000
1) MIX LEVEL
0.0000
3) DEPTH SOFT
0.0000
COMBINER CONTROL
A: Ch 1
B: Ch 2
C: Ch 3
D: Ch 4
Stage 1
N
Stage 2
V
1 2
Stage 3
D