Grass Valley 4300 Krystal Reference Manual v.3.1 - Manual (Page 172)

8-26 Krystal 4300 Reference
Section 8 — Picture Frame Menu
The turn may be towards the front or back of the original plane. Turns may
be executed as a single channel, double channel, or double pass effect. In a
single channel execution, the source video may be applied to both the front
and back. In a double channel/double pass execution, one video source is
applied to the front by one channel, while another video source is applied
to the back by another channel or a second pass with the initial channel.
Press KURL MODE button until PAGE TURN is highlighted to access the fol-
lowing menu.
Page Turn menu functions include:
DIRECTION — OVER and UNDER control whether the page turn is towards the
viewer (OVER) or away from the viewer (UNDER).
SHOW SIDES —press to select BOTH , FRONT , or BACK to show video on both
sides, front side only, or back side only of the page being turned. Press BOTH
if you are using one channel and you wish to show both front and back
video.
Soft Knobs associated with this menu include:
RADIUS —adjusts the radius of the page turn cylinder affecting the
sharpness of the curl.
OFFSET — positions the page turn cylinder with respect to the source
raster and, when interpolated between keyframes, causes the page to
“turn”. The offset would typically change from one edge or corner of
the source raster to the opposite edge or corner for the turn.
ANGLE — defines the orientation of the page turn cylinder with respect
to the source X and Y axes, and specifies the direction of the turn.
KURL
Displayed:
Register:
Keyframe:
Cur.Time:
KURL
MODE
KURL
MODE
OFF
---
SPLASH
RINGS
OFF
SPHERE
SLITS
RIPPLE
SIZE MOD
POS MOD
PAGE ROLL
DIRECTION SHOW
SIDES
ANGLE
0.1000
OFFSET
0.0000
RADIUS
1.0000
BACK
FRONT
BOTH
UNDER
OVER
PAGE TURN