Grass Valley 4300 Krystal Reference Manual v.3.1 - Manual (Page 141)

Krystal 4300 Reference 7-33
Output Recursive Menu
Montage/Timing
The TIMING selection applies to all of the recursive modes and is discussed
near the end of this section on page 7-36 .
Trails/Strobe
The TRAILS selection allows you to leave a trail of old images behind as you
fly an image around the screen. The STROBE selection turns the trail on and
off at regular intervals.
To access the Trails/Strobe selections shown below, press the RECURSIVE
MODE soft button to select TRAILS , and press the MODIFY soft button to select
STROBE .
LOOP — ON starts the recursive effect. OFF stops the recursive effect and
returns to live video.
KEYFRAME RESET — ON resets the loop and starts the effect over again at each
keyframe where Keyframe Reset is on. OFF does not change the image at
each keyframe.
STROBE TYPE — sets type of strobe that will cause automatic capture of new
images or disables automatic capture. The selections and adjustments
below control the strobe cycle.
NONE — turns strobe off.
TIME — captures a new image at an adjustable time interval.
KEYFRAME — captures a new image at each keyframe.
When TIME is selected, the following soft knobs appear:
PERIOD — makes the strobe cycle shorter or longer (shown in frames).
OUTPUT RECURSIVE
Displayed:
Register:
Keyframe:
Cur.Time:
RECURSIVE
MODE
MODIFY LOOP KEYFRAME
RESET
STROBE
TYPE
FORCE
STROBE
OFF
ON
KEYFRAME
TIME
NONE
OFF
ON
OFF
ON
OFF
TRAILS
MONTAGE
MTN DECAY
FREEZE
TIMING
WIND
APPEARNCE
STROBE