TeeJet Legacy 6000 CAN Guide - Manual (Page 99)

Fieldware for the Legacy 6000
Software Version 2.11
Chapter 3 - Real-time Setup 3-29
Job Report Setup
Job Report Setup
A Job Report contains all the necessary information to build an application report after the job is
completed. Application reports are generated in the Fieldware Map Manager desktop program.
Job Report is accessed from the ARM Launcher page (Figure 3-12). Select the Job Report tab and
move to the Main Job Report Page (Figure 3-12). Table 3-3 describes each Job Report menu item.
No PCMCIA Card Selected
If you have the PC Card setting in Console setup set to NO, the Job Report tab will not be an
option on the ARM Launcher page.
Running the Job Report Wizard
The Main job Report Setup page is the page seen when Job Report is first entered (Figure 3-12)
right image. The Job Report page contains every setup item in a list. From this list each Job Report
item can be edited individually or the Job Report Setup Wizard can be run. The top item in the list
is the Setup Wizard. To run the Setup Wizard, highlight in the main list and press
the enter key. The Setup Wizard will walk through the entire Job Report Setup item list.
It is not necessary to fill out any Job Report information in order to start applying products. The Job Report
Information should be filled out if it is desired to write this data to the header of the record file (.RCD).
Figure 3-12: ARM Launcher / Job Report Page