TeeJet Legacy 6000 CAN Guide - Manual (Page 105)

Fieldware for the Legacy 6000
Software Version 2.11
Chapter 3 - Real-time Setup 3-35
Product Setup
Product Setup
Product setup is used to associate a product to a Product Control Module (PCM), as well as setup
preset product application rates. To run Product Setup, select the Product Setup tab in the ARM
Launcher page (Figure 3-17). This brings up the Select PCM page (Figure 3-18).
Running the Product Setup Wizard
When the PCM has been selected, the first page in Product Setup is the Main Product Setup page.
The Main Product Setup page contains every setup item in a list. From this list each Product Setup
item can be edited individually or the Product Setup Wizard can be run. The top item in the list is
the Setup Wizard. To run the Setup Wizard, highlight in the main list and press
the enter key. The Setup Wizard walks through the entire Product Setup item list.
Table 3-5 lists all of the Product Setup items and their descriptions.
Figure 3-17: The ARM Launcher / Product Setup Page