TeeJet Legacy 6000 CAN Guide - Manual (Page 135)

Fieldware for the Legacy 6000
Software Version 2.11
Chapter 4 - Real-time Operation 4-21
Real-time Guidance Operation
Step 3: Establish First Interior Pass
Once you have completed all of your headland passes and the Headland Off button has been
pressed, you can begin applying the first interior pass. Because you have not pressed the Ignore
Headland button, you can still use the headland trajectory for guidance. Pull along side any head-
land trajectory and begin applying, the lightbar should begin to display guidance information. Fig-
ure 26 shows the vehicle applying the first interior pass.
Step 4: Ignore Headland Data
Once the first interior pass has been completed and you intend to continue applying in the interior
of the field, switch to the Ignore Headland pattern. To do this press the current Guidance Pattern
soft-key (should be Headland) and select the Ignore Headland pattern. For more information on
how to switch between guidance patterns see (Changing Guidance Pattern on page 5-13). This
will exclude the headland data from guidance. Figure 27 shows the headland data (depicted by
checker board pattern) excluded from the guidance data. The Ignore Headland button is shown to
the left.
You can continue applying the interior of the field in the ignore headland mode. If for any reason
you need to include the headland data again.
Figure 4-26: Applying the First Interior Pass
Figure 4-27: Applying the Interior in Ignore Headland Mode