TeeJet Legacy 6000 CAN Guide - Manual (Page 107)

Fieldware for the Legacy 6000
Software Version 2.11
Chapter 3 - Real-time Setup 3-37
Product Setup
The Select PCM Page
The Select PCM page (Figure 3-18) displays all PCMs that are setup and running when Product
Setup is entered. Product setup must be run for each PCM to be used in the application process. If
there is only one PCM connected this page will not appear and will advance directly to Product
Setup parameters. Select the desired PCM to begin the Product Setup process for that PCM.
If a PCM that is already setup is not going to be used in real-time product application, it is recom-
mended that PCMs In Use setting is set to No.
Figure 3-18: The Select PCM Page