TeeJet Legacy 6000 CAN Guide - Manual (Page 100)

3-30 Chapter 3 - Real-time Setup
Job Report Setup
Fieldware for the Legacy 6000
Software Version 2.11
Job Report Detailed Description
Item Description
Wind Speed Enter the observed Wind Speed. Units are based on the Units set in Console
Setup. If no wind speed is to be entered, set this to NO.
Wind Direction Enter the observed Wind Direction from the following directions NE, E, SE, S,
SW, W, NW, N and Not Observed.
Temperature Enter the observed Temperature. Units are based on the Units set in Console
Setup. If no temperature is to be entered, set this to NO.
Current Weather Select the appropriate weather condition from the following conditions: Sunny,
Cloudy, Partly Cloudy, and Not Observed.
Soil Moisture Select the appropriate Soil Moisture from the following conditions: Dry, Moist,
Wet, and Not Observed.
Soil Texture Select the appropriate Soil Texture from the following textures Fine, Medium
Course, and Not Observed.
Soil Tillage Select the appropriate Soil Tillage from the following conditions: No Till, Min
Till, Conv Till, and Not Observed.
Soil Condition Select the appropriate Soil condition from the following conditions: Good,
Trashy, Smooth, Rough, and Not Observed.
Crop Name Enter the name of the Crop.
Growth Stage Select the appropriate Growth Stage from the following stages Pre-Plant, Pre-
Emergence, Post Emergence, and Not Observed.
Table 3-3: Job Report Item Descriptions