TeeJet Legacy 6000 CAN Guide - Manual (Page 187)

Fieldware for The Legacy 6000
Software Version 2.11
A-3
Appendix A - PCM Favorites Settings
GRANDC-A SPINMOTOR-A
Favorite: GRANDC-A Favorite: SPINMOTOR-A
Application Granular Application Motor
Application name GRANULAR_MICRO Application name SPINNERS
Configuration Split Drive Configuration Standard
PCM link None PCM link None
Drive Type DC Motor Drive Type Servo
Gain 3
Units lb/ac Start Up Drive 20%
Control Basis Area Master Switch Hold
Implement Status Close
Primary Sensor Granular Valve Delay 1.00s
Input A Valve Location In-Line
Sensor Name MICRO_BIN_SENSOR
Calibration # 1250.0 pul/ft3 Units rpm
Cal# Basis NONE Control Basis Time
Secondary Sensor None Primary Sensor Shaft
Input A
Monitor 1 Low Bin Sensor Name SPINNER_SENSOR
Input B Calibration # 3 pul/ft3
Sensor Name LOW_BIN_LEFT Cal# Basis NONE
Alarm Status High Alarm units rpm
Alarm Delay 5 s Min. Alarm 500
Max. Alarm 1000
Monitor 2 Low Bin Alarm Delay 5 s
Input C
Sensor Name LOW_BIN_RIGHT Secondary Sensor None
Alarm Status High
Alarm Delay 5 s Monitor 1 None
None Monitor 2 None
Monitor 3 Shaft Monitor 3 None
Input D Montior 4 None
Sensor Name FAN_RPM
Calibration # 2.0 pul/r
Alarm units rpm
Min. Alarm Off
Max. Alarm Off
Alarm Delay 10s
Monitor 4 None