TeeJet GPS Speed Sensor - Manual

1801 Business Park Drive, Springfield, Illinois 62703 USA (217) 753-8424 ~ www.teejet.com 98-01187 R8
Antenna Mounting Considerations
1. The antenna must be located in an area with a clear
view of the sky and mounted at the highest point on the
vehicle in the center of the roof.
2. If the vehicle is non-metallic, attach the metal mounting
plate via the Velcro™ strips. Place the antenna on the
metal plate.
3. Avoid overhead metal objects that may interfere with
satellite signals.
4. Avoid mounting in areas that receive excessive vibration.
5. Mount antenna away from sources of electromagnetic
output such as radio antennas and electric motors.
6. Make sure the antenna’s cable can be safely routed to
the cab from the mounting position.
GPS Status
Indicator
Antenna Installation
1. Make sure the surface of the vehicle is clean, dry, and
free of dust particles.
2. Magnetically mount the antenna to a metal surface.
3. If the vehicle is non-metallic, attach the metal mounting
plate via the Velcro™ strips. Place the antenna on the
metal plate.
GPS Speed Sensor Installation
1. Place the GPS Speed Sensor in a location inside the
vehicle that is easily viewed while driving.
2. Mount the GPS Speed Sensor using the two screws or
Velcro™ (included).
3. Connect the GPS Speed Sensor cable to the Rate Con-
troller (see Misc. Adapter Cables, page 2).
4. Connect the antenna cable to the antenna SMA Connec-
tor on the back of the GPS Speed Sensor.
Power Indicator A solid light indicates power.
GPS Status Indicator GPS is detected. The light will
blink consistently when vehicle
moves. If the vehicle is stationary,
the LED will blink irregularly.
Speed Indicator LED will blink when a a ground
speed signal is present.
Metal Mounting
Plate 65-05055