TeeJet Legacy 6000 CAN Guide - Manual (Page 190)

B-2
Appendix B - Creating a Calibration Table
Fieldware for The Legacy 6000
Software Version 2.11
Loading Calibration Table in Legacy 6000
Loading the Calibration Table can be done in Five simple steps. With the console off place the PC
Card in the Legacy 6000 and power the console on.
1. From the Main launcher page select the View Systems Tools
button (wrench and ruler).
2. Select Device Manager from the system tools page.
3. From the device manager page select the Console device. Use
the Up and Down arrows to scroll through the devices in the middle
of the screen.
4. Locate and select the Update Console Using System Files but-
ton. This button will be the PC Card with a green arrow pointing to
the left.
5. From the Update Files page us the Up and Down arrows to
locate Cal Table in the middle of the screen. Once Cal Table has
been located press the Update Console button (PC Card with
green arrow pointing to the left). Once pressed a information bar
will appear stating the console is being updates, when this bar is
gone the console has been updated and the Cal Table has been
loaded on the Legacy 6000.