TeeJet Legacy 6000 CAN Guide - Manual (Page 95)

Fieldware for the Legacy 6000
Software Version 2.11
Chapter 3 - Real-time Setup 3-25
Prime Injection System
Prime Injection System
Priming feature will only appear as an option if Injection has been selected as the Drive type during
PCM setup. Priming is an Injection feature only. Priming the injection system can be done in three
easy steps. Priming the system will take chemical from the injection storage tank directly to the
injection point to ensure chemical is injected instantly upon the start of an application. NOTE:
Injection Calibration must be completed prior to priming for the system to properly prime.
1. Calculate Prime value
Calculate the Prime value using the formula below, this value should be entered during PCM setup
Drive Type Injection (See “Drive Type Settings” on page 2-25.)
Calculating the Prime Value
(Line diameter/2) X 3.1416 X Line length X 0.5541 = Volume in Fluid Ounces