TeeJet Legacy 6000 CAN Guide - Manual (Page 116)

4-2 Chapter 4 - Real-time Operation
Product Application
Fieldware for the Legacy 6000
Software Version 2.11
Product Application
When the Real-time Setup process is complete, (See “Chapter 3 - Real-time Setup” on page 3-1.),
product application can begin. This is accomplished by pressing the ARM Bull’s-eye located in the
ARM Main Launcher page (Figure 4-1).
When the ARM Bull’s-eye soft-key is pressed, the Fieldware ARM software loads the PCM and
Implement setup information and Control parameters and data files. This loading process may
take a few seconds to complete. When the loading process is complete, the Rates page (Figure 4-
3) is the first real-time page seen.
Real-time pages
There are four real-time pages, three Information pages and one Map page. Each will be
described in more detail.
Figure 4-1: The ARM Launcher Page
Figure 4-2: Real-time Pages
ARM Bull’s-eye
soft-key