TeeJet Legacy 6000 CAN Guide - Manual (Page 97)

Fieldware for the Legacy 6000
Software Version 2.11
Chapter 3 - Real-time Setup 3-27
Reverse Prime Injection System
Reverse Prime Injection System
Reverse Prime does not come standard on the peristaltic injection pump. Reverse Prime can be
added as a feature. Call your local Mid-Tech distributor to order the reverse prime feature using
Part# 54-02015.
Reverse prime works very similar to the priming procedure. Reverse Priming the system will take
chemical from the injection point directly back to the storage tank to save as much chemical as
possible. To Reverse Prime the system use the Prime button from the ARM Launcher page, this
button will only appear as an option if Injection has been selected as the Drive type during PCM
setup. Priming and Reverse Priming is an Injection feature only. Reverse Priming the injection sys-
tem can be done in two steps if the system has been properly primed and a prime value has been
calculated (See “1. Calculate Prime value” on page 3-25.)