TeeJet Legacy 6000 CAN Guide - Manual (Page 119)

Fieldware for the Legacy 6000
Software Version 2.11
Chapter 4 - Real-time Operation 4-5
Product Application
Test Speed
To simulate a speed without moving the operator can use a function call Test Speed. Test Speed is
accessed by pressing the System Devices button. Locate the PSM device and press the Test
Speed button. Turn Test Speed on and enter the speed for simulation. NOTE: once setting are
applied the system will start to operate at the entered test speed. If boom and pump are on the
system will begin to apply. Apply the settings by pressing the green forward arrow. Press the red
back arrow to return to the rate page and start using test speed. The rate page will show the speed
highlighted black to indicate Test Speed is active.
Reset Initial Quantity
Initial quantity is a feature used to count down the product remaining to be applied. To rest this
valve press the rest Initial Quantity button. Initial Quantity is set during Product Setup.
Figure 4-7: Manually Adjusting an Application Rate
Figure 4-8: Manually Adjusting an Application Rate
System Devices
Soft-keys
Test Speed Button
Reset Initial Quantity
Soft-keys