TeeJet Legacy 6000 CAN Guide - Manual (Page 62)

2-32 Chapter 2 - Getting Started
Product Control Module (PCM) Setup
Fieldware for the Legacy 6000
Software Version 2.11
Secondary Sensor Settings
Secondary Sensors Granular, Shaft, Pressure Digital, and Pressure Analog have detailed settings
that are the same. Review (Table 2-17) for a detailed description of the settings that are the same.
The two Pressure Sensors, Pressure Digital and Pressure Analog, have the initial settings as well
as an sub settings. Accessing the sub settings locate the two Settings Buttons on the right side of
the screen, use the two buttons to swap between settings.see (Figure 2-32) above. Review (Table
2-18) for a detailed description of the sub settings for Pressure Digital and Pressure Analog Sec-
ondary Senors. When the Secondary Sensor settings and parameters are selected, press the For-
ward arrow to advance to the next PCM Setup page
Sensor Settings Definition
Input Defines digital and analog sensors. Senor inputs A-D are digital (flowemeter,
and slot sensors) and Senors E-F are analog (pressure).
Sensor Name A user defined name used to label a particular sensor or monitor. This informa-
tion is not stored in the PCM and is used for messaging to the user only.
Dual Warning% Defines the maximum acceptable % difference between the primary and sec-
ondary sensor outputs before the operator is warned.
Dual Warning Delay Defines the time that the primary and secondary senors outputs can exceed
the dual warning % before initiating the alarm.
Table 2-17: Secondary Sensor - Settings