TeeJet Legacy 6000 CAN Guide - Manual (Page 117)

Fieldware for the Legacy 6000
Software Version 2.11
Chapter 4 - Real-time Operation 4-3
Product Application
Information Pages
There are three information pages consisting of two Rate pages and a GPS / Boundary page.
Rate Pages
The Rate pages display various information related to the product and associated PCM. Highlight-
ing a product control soft-key determines which rate information is displayed on the rates page.
The Rates page displays the product name at the top of the page as well as the current rate, cur-
rent speed, material applied, acres applied, and remaining amount of material and acres. A com-
pleted field boundary must exist to calculate the remaining acres. To view the remaining amount of
product, the initial volume of material must be entered in Product Setup. For each product (PCM)
there is also an alternative rates page (Figure 4-3) Right image. Information in this page varies
based on the PCM configuration. This page typically displays the active swath width and additional
sensor or monitor status information.
GPS / Boundary Page
The GPS / Boundary page displays the current Latitude and longitude vehicle position, Antenna
Height, GPS speed, Course in degrees (North 0
o
), Bounded acres.
Figure 4-3: The Main Rate Page and Alternate Rate Page
Figure 4-4: The GPS / Boundary Page
Product Control
Soft-key
Change Page
Soft-key