TeeJet Legacy 6000 CAN Guide - Manual (Page 72)

3-2 Chapter 3 - Real-time Setup
Operation Overview
Fieldware for the Legacy 6000
Software Version 2.11
Operation Overview
When the System Setup process is complete, product application setup can begin. This is accom-
plished by pressing the ARM Bullseye located in the Fieldware Main Launcher page (Figure 3-1).
Prior to actually starting product application it is necessary to follow a short setup process. The
steps in this process will vary based on how the software is setup, how many products are being
applied, and most importantly whether the delivery system has been calibrated. This Chapter cov-
ers Calibration, Job Report (Weather and Soil conditions), ARM setup (date Storage files), Product
setup. When ARM is setup properly product application can begin. Prior to starting real-time prod-
uct application we recommend that (See “Chapter 4 - Real-time Operation” on page 4-1.) be
reviewed.
The first time through these operate setup steps will take the longest amount of time. When the
system has been calibrated and are file naming and product setup is understood, these operate
setup steps can be accomplished in just a minute or two. Table 3-1 outlines the operate setup
steps. Each step listed in the table is described in more detail in specific sections of this chapter.
Figure 3-1: Fieldware Main Launcher
Operate ARM
Button
System Setup