Metrohm 916 Ti-Touch - Manual (Page 94)

10.3 Monitoring the working life
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
78 ￭￭￭￭￭￭￭￭
916 Ti-Touch
Define the limit values for monitoring the slope and the electrode zero
point (see Chapter 10.5, page 83).
[Calibration interval]
This button is displayed only for pH electrodes.
Define the time interval for the next calibration (see Chapter 10.6, page
84).
[Calibration data]
This button is displayed only for pH electrodes.
Display the properties for titer determination (see Chapter 10.4, page
79).
10.3 Monitoring the working life
Sensor: Edit ▶ Working life
In the dialog Edit sensor / Working life, you can define the time inter-
val after which the sensor must be replaced. If you do not wish to monitor
the working life, then you can enter only the date of manufacture for doc-
umentation purposes.
Start-up
Date on which the sensor was used for the first time.
Format: YYYY:MM:DD
Monitoring
on | off (Default value: off)
If this parameter is activated, then the working life will be monitored.
Working life
If you define a time interval for the working life, then the Expiry date will
be tracked automatically.
Input range 1 - 999 days
Default value 999 days
Expiry date
If you define an expiry date, then the Working life will be tracked auto-
matically.
Format: YYYY:MM:DD