Metrohm 916 Ti-Touch - Manual (Page 151)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
13 GLP manager
916 Ti-Touch
￭￭￭￭￭￭￭￭ 135
[Delete]
Delete the selected test tool from the list.
[Edit]
Change the designation of the selected test tool.
13.3 GLP tests for measurement and titration
Main dialog: System ▶ GLP manager ▶ GLP tests HW/SW ▶ GLP
test "Measurement" / GLP test "Titration"
You can document the GLP tests for measurements and titrations in the
dialog GLP manager / GLP tests Hardware/Software and its subdia-
logs. The following procedure describes the GLP test "Measurement," but
also applies for the GLP test "Titration".
Proceed as follows:
1 Open the properties dialog
￭ In the dialog System / GLP manager, tap on the button [GLP
tests HW/SW] and then on the button [GLP test "Measure-
ment"].
2 Edit data
￭ Define the test method, the test results, etc. (see "Dialogs "GLP
tests HW/SW / GLP test "Measurement"" and "GLP tests HW/SW /
GLP test "Titration""", page 136).
3 Define the hardware used
￭ Tap on [Hardware].