Metrohm 916 Ti-Touch - Manual (Page 55)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 System settings
916 Ti-Touch
￭￭￭￭￭￭￭￭ 39
[Command list]
Block unneeded method commands (see "Blocking unneeded commands
and fixed keys", page 39).
[Fixed keys]
Block unneeded fixed keys (see "Blocking unneeded commands and fixed
keys", page 39).
[Routine dialog]
Configure functions for the routine dialog (see "Configuring the routine
dialog", page 40).
Selecting the dialog mode
Proceed as follows to change the dialog mode:
1 Select the dialog mode
Open the selection list Dialog and select either Expert dialog or
Routine dialog.
2 Save the settings
Tap on the fixed keys [ ] or [ ].
The setting will apply to all dialogs.
NOTE
If you have selected Routine dialog and if the routine dialog was
configured in such a way that the dialog System settings / Dia-
log options is blocked, then you can switch back over to the
expert dialog as follows:
￭ Operation without login function:
In the main dialog, enter User = Metrohm.
￭ Operation with login function:
A user who works with expert dialog must log in.
Blocking unneeded commands and fixed keys
This following configurations apply for both dialog modes: routine dialog
and expert dialog.