Metrohm 916 Ti-Touch - Manual (Page 315)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
28 Parameters
916 Ti-Touch
￭￭￭￭￭￭￭￭ 299
Measuring mode pH:
Input range
–20.000 - 20.000
Selection off
Default value off
Measuring mode U, Ipol:
Input range
–2,000.0 - 2,000.0 mV
Selection off
Default value off
Measuring mode Upol:
Input range
–200.0 - 200.0 µA
Selection off
Default value off
Stop EP
The titration is stopped when the specified number of equivalence points
has been found.
Input range 1 - 9
Default value 9
Selection off
Volume after EP
This volume will be added when the number of equivalence points
defined under Stop EP has been found. The curve shape after the equiva-
lence point can also be seen this way.
Input range 0.01000 - 9999.99 mL
Selection off
Default value off
Stop time
The titration is stopped when the specified time has elapsed since the start
of the titration.
Input range 0 - 999999 s
Selection off
Default value off
Filling rate
Rate at which the dosing cylinder is filled.
Input range 0.01 - 166.00 mL/min
Selection maximum
Default value maximum