Metrohm 916 Ti-Touch - Manual (Page 110)

11.4 Metrohm control devices
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
94 ￭￭￭￭￭￭￭￭
916 Ti-Touch
Entry x.x.x.x
Default value empty
MAC address
Unambiguous address of the network adaptor for identification within a
network. This parameter cannot be edited.
NetBIOS name
Unambiguous designation of the device within the network. This parame-
ter cannot be edited.
11.4 Metrohm control devices
The following Metrohm devices can be used as control devices:
￭ Ti-Touch Titrator (permanently entered as control device in the device
manager)
￭ USB Sample Processors
The following specifications apply for all of the control devices mentioned
above. Additional device configurations for the USB Sample Processor are
described in a separate chapter (see Chapter 11.5, page 97).
The dialog shows the control device with its measuring inputs, the MSB
connectors and connected peripheral devices (dosing device, stirrer,
Remote Box).
[Properties]
Open the properties dialog of the highlighted entry.
The following properties can be displayed and edited to a certain extent:
￭ Properties of the measuring inputs (see Chapter 11.4.1, page 95)
￭ Properties of the MSB connectors (see Chapter 11.4.2, page 96)