Metrohm 916 Ti-Touch - Manual (Page 268)

27.2 Measuring
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
252 ￭￭￭￭￭￭￭￭
916 Ti-Touch
NOTE
Manual control can also be exited when a manual sequence has been
started but has not yet ended. The fact that a sequence has been
started in manual control can be recognized by the corresponding sym-
bol in the title line (see Chapter 6.2.3, page 32).
27.2 Measuring
Manual control ▶ Measure
Manual measurements can be carried out with the function [Measure].
Proceed as follows:
1 Select a sensor
￭ Select the desired sensor from the sensor list.
All of the sensors available in the sensor list are displayed. Sensors
are defined under System
▶ Sensors.
￭ Select the measuring input at which the sensor is connected.
2 Select a measuring mode
￭ Select the desired measuring mode.
Only those measuring modes are displayed which are advisable
for the selected sensor.