Metrohm 916 Ti-Touch - Manual (Page 281)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
27 Manual control
916 Ti-Touch
￭￭￭￭￭￭￭￭ 265
27.5 Remote
Manual control ▶ Remote
With the function [Remote], you can define manual output signals to the
remote interface of a connected Remote Box. It is not possible to define
input signals; the current status of the input lines is, however, displayed.
Inputs
Current status of the input lines.
Outputs
Selection of the signal out of the templates or entering the required bit
pattern. Templates are defined under System
▶ Templates ▶ Output
lines.
Entering the bit pattern:
￭ 0 = line inactive
￭ 1 = line active
￭ * = retain line status
￭ p = set pulse
The output lines are always numbered from right to left, i.e. with the sig-
nal 00000000000001 line 0 is set. With a pulse, the length is set to 200
ms. If you wish to set pulses with other lengths, you have to define a cor-
responding template.
Entry Bit pattern containing exactly 14 characters
or a max. of 24 characters for the name of
the template
Default value 00000000000001
Selection Selection of the templates defined