Metrohm 916 Ti-Touch - Manual (Page 414)

28.14 Miscellaneous commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
398 ￭￭￭￭￭￭￭￭
916 Ti-Touch
Message text
This parameter can only be edited when Message is activated.
Text which is displayed during the waiting time.
Entry max. 28 characters
Default value empty
28.14.3 Scan data (REQUEST)
The following data can be scanned in the method run with the command
REQUEST:
￭ Sample data
– Sample identification 1
– Sample identification 2
– Sample size (value and unit)
￭ Common variable
You can select thereby whether the sequence should be paused or
resumed in the background.
Sample ident.
Selection of the sample identification that is queried in the method run.
Selection off | Identification 1 | Identification 2 | ID1 &
ID2
Default value off
Sample size
on | off (Default value: on)
If this parameter is activated, then the value for the sample size will be
requested.
Sample size unit
on | off (Default value: off)
If this parameter is activated, then the unit for the sample size will be
requested.
Common variable
Selection of the common variable which is queried in the method run.
Selection CV01…CV25 | off
Default value off