Metrohm 916 Ti-Touch - Manual (Page 18)

1.1 Instrument description
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 ￭￭￭￭￭￭￭￭
916 Ti-Touch
￭ MET
Monotonic equivalence point titration. The reagent is added in con-
stant volume steps.
Measuring modes:
– pH (pH measurement)
– U (potentiometric voltage measurement)
– Ipol (voltametric measurement with selectable polarization cur-
rent)
– Upol (amperometric measurement with selectable polarization
voltage)
￭ SET
Endpoint titration at one or two specified endpoints.
Measuring modes:
– pH (pH measurement)
– U (potentiometric voltage measurement)
– Ipol (voltametric measurement with selectable polarization cur-
rent)
– Upol (amperometric measurement with selectable polarization
voltage)
￭ MEAS
Measuring modes:
– pH (pH measurement)
– U (potentiometric voltage measurement)
– Ipol (voltametric measurement with selectable polarization cur-
rent)
– Upol (amperometric measurement with selectable polarization
voltage)
– T (temperature measurement)
￭ CAL
pH electrode calibration.
Measuring mode:
– pH (calibration of pH electrodes)
– ELT (Electrode test for pH electrodes)
1.1.2 Connectors
The 916 Ti-Touch is equipped with the following connectors:
￭ Mains connection
For connecting to the mains supply with the aid of the power supply
unit provided.
￭ Two MSB connectors (Metrohm Serial Bus)
For connecting dosing devices, stirrers or a Remote Box.
￭ USB connector
For connecting peripheral devices (printer, PC keyboard, etc.), a USB
Sample Processor, a USB flash drive or a USB hub.