Metrohm 916 Ti-Touch - Manual (Page 39)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Installation
916 Ti-Touch
￭￭￭￭￭￭￭￭ 23
NOTE
The electrode cable is protected against accidental disconnection
of the cable by means of a pull-out protection. If you wish to
remove the plug, you will first need to pull back the outer plug
sleeve.
4.6.5 Connecting a temperature sensor or an electrode with integrated
temperature sensor
A temperature sensor of the Pt1000 or NTC type can be connected to the
Temp. connector.
Connect the temperature sensor or the electrode with integrated temper-
ature sensor as follows:
1 Plug the temperature sensor plugs into the Temp. sockets of the
Ti-Touch.
Figure 10 Connecting a temperature sensor or an electrode with
integrated temperature sensor