Metrohm 916 Ti-Touch - Manual (Page 278)

27.3 Dosing
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
262 ￭￭￭￭￭￭￭￭
916 Ti-Touch
Figure 20 Live display "Preparing the exchange unit"
27.3.4 Emptying
Manual control: Dosing ▶ Empty
NOTE
The function Empty is possible only with dosing units.
The cylinders and the tubings of the dosing unit are emptied with this
function.
If the titrant is selected (see "Selecting the dosing function", page 255),
the parameters defined for the titrant for preparing/emptying and the tub-
ing parameters will be used. If the titrant is not selected, default parame-
ters will be used (see Chapter 31.2.2, page 407 and Chapter 31.1.2,
page 406).
27.3.5 Filling
Manual control: Dosing ▶ Fill
You can use the function [Fill] to fill the dosing cylinder of the exchange
unit/dosing unit manually. The filling rate cannot be configured; the maxi-
mum filling rate will be used.