Metrohm 916 Ti-Touch - Manual (Page 269)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
27 Manual control
916 Ti-Touch
￭￭￭￭￭￭￭￭ 253
3 Enter a measuring temperature
￭ Enter the measuring temperature if no temperature sensor is con-
nected. If a temperature sensor is connected, then the tempera-
ture will be measured automatically.
This temperature is used for automatic temperature compensation
with pH measurements.
4 Start the measurement
￭ Tap on [Start].
The measured value display is opened:
The ongoing measurement is canceled with [Stop]. The label
switches once again to [Start].
27.2.1 Parameter description
Dialog "Manual control / Measure"
Sensor
Selection of the sensor from the sensor list. Sensors are defined under
System
▶ Sensors.
Selection Selection of configured sensors
Measuring input
Selection of the measuring input the sensor is connected to. The selection
depends on whether the control device has one or two measuring interfa-
ces.
Selection 1 | 2
Default value 1