Metrohm 916 Ti-Touch - Manual (Page 168)

15.1 Sample data
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
152 ￭￭￭￭￭￭￭￭
916 Ti-Touch
￭ Sample identifications(see Chapter 15.1.1, page 152)
List with sample identifications. If you must enter the sample identifica-
tion before starting a determination, then you can select the entries
contained in this list.
￭ Sample assignments (see Chapter 15.1.2, page 153)
You can assign a particular method to a sample identification.
Use sample identification list
on | off (Default value: off)
Activate this parameter so that the sample identifications defined in the
list will be displayed as selections.
Use sample assignment table
on | off (Default value: off)
Activating/deactivating the use of the sample assignment table.
NOTE
If this parameter is activated, the following will no longer be possible:
￭ Carrying out determinations without their sample identification
being defined in the sample assignment table.
￭ Defining a method in the sample table. Previously defined methods
will be ignored.
Assignment ident.
Identification which is used as assignment identification to load the cor-
rect method.
Selection Identification 1 | Identification 2
Default value Identification 1
Request assignment identification
on | off (Default value: off)
If this parameter is activated, then the sample identification will be reques-
ted automatically at the start of a determination.
15.1.1 Sample identification list
Main dialog: System ▶ Templates ▶ Sample data ▶ Sample identifi-
cation list