Metrohm 916 Ti-Touch - Manual (Page 40)

4.6 Connecting sensors
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
24 ￭￭￭￭￭￭￭￭
916 Ti-Touch
NOTE
The red plug must always be plugged into the red socket for the
purpose of shielding against disruptions.
If you use an electrode with an integrated NTC sensor, then you
must plug the red plug into the red socket.
4.6.6 Connecting an iConnect
An external 854 iConnect measuring interface can be connected to the
916 Ti-Touch.
Connect the iConnect as follows:
1 Plug the iConnect plug into the iConnect socket of the Ti-Touch.
Take care to ensure that the marking on the plug matches the mark-
ing on the Ti-Touch as shown in the figure.
Figure 11 Connecting the iConnect
The iConnect is detected automatically and entered as measuring
input into the device properties of the Ti-Touch. If an electrode is
connected to the iConnect that is not yet included in the list of sen-
sors for the Ti-Touch, then a corresponding message will be dis-
played.
The iConnect can be plugged in and unplugged while the Ti-Touch is
switched on.