Metrohm 916 Ti-Touch - Manual (Page 309)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
28 Parameters
916 Ti-Touch
￭￭￭￭￭￭￭￭ 293
Selection maximum
Default value maximum
maximum
The maximum dosing rate depends on the cylinder volume (see Chap-
ter 31, page 406).
Pause
Waiting time, e.g. for the electrode to settle down after the start or a
reaction time after the dosing of a start volume. The time entered here is
only running when all start conditions have been fulfilled.
Input range 0 - 999999 s
Default value 0 s
More start conditions
Start meas. value
Before starting the titration, it will be dosed until this measured value is
reached. If the start measured value is reached by the dosing of a start
volume, then the titration starts directly.
The values that are actually measurable may vary from the values specified
here, depending on the hardware. The binding measurement value ranges
can be found in the 32 Technical specifications chapter, page 429.
Measuring mode pH:
Input range
–20.000 - 20.000
Selection off
Default value off
Measuring mode U, Ipol:
Input range
–2,000.0 - 2,000.0 mV
Selection off
Default value off
Measuring mode Upol:
Input range
–200.0 - 200.0 µA
Selection off
Default value off
Start slope
Before starting the titration, it will be dosed until this slope (measured
value per volume) is reached. If the start slope is reached by the dosing of
a start volume, then the titration starts directly.
Measuring mode pH:
Input range
00.000 - 9,999 pH/mL