Metrohm 916 Ti-Touch - Manual (Page 114)

11.5 USB Sample Processor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
98 ￭￭￭￭￭￭￭￭
916 Ti-Touch
The dialog shows the USB Sample Processor with its tower (or towers), the
MSB connectors and connected peripheral devices (dosing unit, stirrer,
Remote Box). If the control device is not connected, then the properties
dialog of the control device will be displayed directly (see Chapter 11.5.1,
page 98).
The settings of the MSB connectors and the connected peripheral devices
are described in Chapter "Properties – MSB connector", page 96.
[Racks]
Configure sample racks (see Chapter 11.6, page 105).
[Running time]
Configure the running time meter.
The running time meter adds together the time while the USB Sample Pro-
cessor is "busy" i.e. when a single action is being carried out. A message
with the prompt to service the device is displayed after expiry of the time
limit set here. We recommend to carry out a service after 1000 operating
hours. A reset of the running time meter can only be carried out by a
Metrohm service technician.
[Properties]
Open the properties dialog of the highlighted entry.
11.5.1 Properties – Sample Processor
List of devices: Sample Processor ▶ Edit ▶ Properties
Device name
This designation is used for identification purposes when selecting control
devices (command, manual control).
Entry 24 characters maximum