Metrohm 916 Ti-Touch - Manual (Page 193)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
16 Methods
916 Ti-Touch
￭￭￭￭￭￭￭￭ 177
Statistics
on | off (Default value: off)
If this parameter is activated, then statistics calculations will be carried out
for all of the defined results. The prerequisite here, however, is that a vari-
able for the mean value is defined in the result options (see "Dialog "Edit
calculation / Result options"", page 358).
Number of determinations
The number of determinations that are carried out for the statistics calcu-
lations.
If an additional determination has to be added to the determination
series, because one determination has been incorrect, for example, then
this can be accomplished in the statistical overview (see Chapter 24, page
231).
Input range 2 - 20
Default value 3
[Save automat.]
Define the settings for automatically saving the determination (see Chap-
ter 16.5.6, page 184).
[Properties]
Display the properties of the current method (see Chapter 16.5.4, page
184).
[Note]
Enter a note on the method (see Chapter 16.5.5, page 184).
[Start/Stop options]
Edit functions which are carried out immediately after the method is
started or stopped, see chapter Start options, page177 and chapter Stop
options, page 179.
[Sample data]
Specify method-specific settings for the sample data, e.g. designation of
the sample identifications, limits for the sample size (see Chapter 16.5.3,
page 180).
16.5.1 Start options
Main dialog: Edit parameters ▶ Method options ▶ Start/Stop
options ▶ Start options
In the dialog Method options / Start options, you can configure the
functions which are carried out when a determination is started.