Metrohm 916 Ti-Touch - Manual (Page 412)

28.14 Miscellaneous commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
396 ￭￭￭￭￭￭￭￭
916 Ti-Touch
Input range 0 - 999
Default value 1
Selection Calibration
Calibration
For automatic calibrations with a USB Sample Processor (see Chapter
31.7, page 413).
[Note]
Entering a note on the subsequence.
Dialog "Subsequence options / Note"
A short text can be entered in this dialog, e.g. for the description of the
subsequence commands or for the application purpose.
[Display options]
Definition when the note is being displayed.
Automatically after loading the subsequence
on | off (Default value: off)
If this parameter is activated, the note is displayed when loading the sub-
sequence. It can otherwise only be read in this dialog.
28.14 Miscellaneous commands
28.14.1 Controlling a stirrer (STIR)
A stirrer is controlled with the command STIR.
Control device
This parameter will only be shown when, in addition to the Ti-Touch, a
Sample Processor has been configured as control device. Control devices
are defined under System
▶ Device manager.
Selection of the control device from the list of devices.
Selection Selection of configured control devices
Stirrer
Selection of the MSB connector the stirrer is connected to. The selection
does not depend on the number of MSB connectors of the control device.
Selection 1 | 2 | 3 | 4
Default value 1
Status/Duration
Switching the stirrer on or off.